Framework Laptop Stand

LOVE the original design - I made a couple of mods as I didn't have a 'bic' pen to use.

1) I combined the left side, right side, and spacer into one piece. Rotating 45 degrees, it still (barely) fit on my build plate.

2) I printed a 'pin' to connect the pieces together instead of the pen case.

For assembly, the pin is the exact width needed to superglue the logos to each end after it is inserted into the assembled pieces.

There are 3 STL files needed:
1) Framework Laptop-A - which is the left and right sides with the spacer between them. You will need 2 of these printed.

2) Framework Laptop-B - which is the center piece, 2 logos (one for each side) and the two prop pieces (large and small). You will need 2 of these printed.

3) Framework Laptop-C - which is the 'pin' to use to raise and lower the stand. This includes 2 pins so you only need to print this once. HIGHLY recommend that you slice this one with infill at 100%.

If you like this, please let the or