Thingiverse
FREHD Case
von djones60
11
Downloads
2
Likes
1
Makes
This was designed or the NewMatter Mod-T printer using PLA.
The case may need a brim to prevent lifting at the corners. Inside the design there is commented out option for printing a small brim at the corners.
There are two sets of stand offs. One is for the PCB and the other is for the cover screws. The holes in the stand off may need to be drilled out or tapped depending on what you are wanting or your screw size. Also the cover screws need to be 1 1/4 inch. You can make the standoffs taller and their holes to match for shorter screws.
The LED holes don not line up with their location on the PCB. This is because I put mine on short cables so they could be better located and mounted pointed forward instead of upward. The holes are for 3mm LEDs.
The case may need a brim to prevent lifting at the corners. Inside the design there is commented out option for printing a small brim at the corners.
There are two sets of stand offs. One is for the PCB and the other is for the cover screws. The holes in the stand off may need to be drilled out or tapped depending on what you are wanting or your screw size. Also the cover screws need to be 1 1/4 inch. You can make the standoffs taller and their holes to match for shorter screws.
The LED holes don not line up with their location on the PCB. This is because I put mine on short cables so they could be better located and mounted pointed forward instead of upward. The holes are for 3mm LEDs.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!