Thingiverse
Frenchie
door Sculptor
279
Downloads
344
Likes
15
Makes
Meet Frenchie!
Sculpted in Zbrush, about 20-25 h of sculpting (I think).
I worked hard to achieve that french look :)
This sculpture is printable without support as usual.
For the printed model in the picture I used ColorFabb's WoodFill fine PLA. It has 30% wood in it which makes it perfect to sand down imperfections. I then covered it with gray primer.
If you want to see more of my characters:
http://olasundberg.com
Cheers
/Sculptor
Sculpted in Zbrush, about 20-25 h of sculpting (I think).
I worked hard to achieve that french look :)
This sculpture is printable without support as usual.
For the printed model in the picture I used ColorFabb's WoodFill fine PLA. It has 30% wood in it which makes it perfect to sand down imperfections. I then covered it with gray primer.
If you want to see more of my characters:
http://olasundberg.com
Cheers
/Sculptor
Sculptor publiceert ook op
3 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
