Thingiverse
Frisbee
von mgg942
201
Downloads
156
Likes
0
Makes
This is a Frisbee made for my grandson, Logan. Designed in MOI (Moment of Inspiration), and made in DiamondAge PLA on an Ultimaker.
I was doubtful that it would print without support but it did, though it doesn't look that great even after a clean up.
Flies well, though!
175 mm O/D, weight 31 gms.
I was doubtful that it would print without support but it did, though it doesn't look that great even after a clean up.
Flies well, though!
175 mm O/D, weight 31 gms.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
