Thingiverse
FT5 CoreXY Conversion
von Rajaa
246
Downloads
122
Likes
0
Makes
Important update: Don't use steel-core belts, they'll cause wrong print dimensions after a while.
-Replaced the files with the new V2 files. 27/07/2017
-New little adjustments made toady 1/08/2017
-Lowered (1.5mm) the high idler of the left carriage (because the toothless idler height is 10mm, not 9mm like the toothed one), changed Y endstop holes, and corrected a small error in Extruder mount tensioner holes. 2/08/2017
-Corrected the holes position in the parts "Right idlers mount 2" and "Left idlers mount 2" (they were off by like 0.5mm). 3/8/2017
-Uploaded Fan Mount v2. 6/08/2017
-Changed stepper mounts. 19/9/2017
-Updated belt tensioner. 30/11/2017
-Added letters (L&R) to the parts to indicate left and right. Updated the left and right carriages to use M5 nuts instead of using the carriage itself as a nut for the idlers screws (easier to work with) and slightly adjusted their design. check the last rendering picture. Changed all the idlers to F695zz Flanged Bearing 5x13x4
-Replaced the files with the new V2 files. 27/07/2017
-New little adjustments made toady 1/08/2017
-Lowered (1.5mm) the high idler of the left carriage (because the toothless idler height is 10mm, not 9mm like the toothed one), changed Y endstop holes, and corrected a small error in Extruder mount tensioner holes. 2/08/2017
-Corrected the holes position in the parts "Right idlers mount 2" and "Left idlers mount 2" (they were off by like 0.5mm). 3/8/2017
-Uploaded Fan Mount v2. 6/08/2017
-Changed stepper mounts. 19/9/2017
-Updated belt tensioner. 30/11/2017
-Added letters (L&R) to the parts to indicate left and right. Updated the left and right carriages to use M5 nuts instead of using the carriage itself as a nut for the idlers screws (easier to work with) and slightly adjusted their design. check the last rendering picture. Changed all the idlers to F695zz Flanged Bearing 5x13x4
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
