Full Width Light Bar

This is a simple modification of version of https://www.thingiverse.com/thing:4849418 (an LED fixture I created for my own needs), at the request of Allan47. I believe the intent is to be used on a CR10S which is laid out differently than my Sidewinder X1. The housings are designed to fit on a 300x 300 bed. This is an untested modification in this configuration. This fixture situates the LED lights near the outside perimeter of the build plate so the parts aren't in the shadows of the gantry and extruder.

I simply cut ends off the earlier version, extended slightly and mirrored the bodies. This configuration is apt to require a couple of screws mid section due to extra length.

Bottom housing was designed for a single t-nut on each end to hold in the t slot rails. The original fixture had 4 snap tabs to hold top housing to bottom, but due to layer direction, they didn't hold up so well. The intent to hold the top housing to the bottom is by sticking a piece of 1.75mm filam