Functional Desktop/Bedside Clock

 
Designed from the ground up for 3D printing BoBo Clock makes for a nice little companion at your desk or bedside table.
 
You can get the quartz movement for the clock here.





 
Assembly
The assembly can be done in 2 minutes without using any screws or glue.

Step 1
The first step is to attach the legs to the back. This is done by inserting each leg, then twisting it 90 degrees to lock it in place.


 

Step 2
Now insert the shaft of the clock movement into the front, tightening it into place using the included nut.


Step 3
Now attach the hour and minute hand onto the shaft. Most likely the holes will be too small due to deformation during printing. To solve for this just use a sandpaper/knife for a few seconds to enlarge the hole. Just be careful not to make the holes too big.

Once the hands are attached move them both to midnight and then set the correct time using the dial on the back.


If you want you can add a minute hand to the clock as w