Thingiverse
Funko Modular Shelf
von dexter16
63
Downloads
66
Likes
0
Makes
I designed a very simple modular shelf that you can print very quickly with just a small amount of filament.
You can print 2 legs and 1 top, or if you want you can use 3 legs with 2 tops to make it larger
I used the Standard Profile on Cura with an Ender 3 V2
- Funko Leg takes 38min
- Funko Top takes 57min
A set of 2 legs and one top with my configurations uses about 16g (5.5m) of filament
The top part can be scaled to make it larger, but this size should be perfect for most pop figures.
I'm working on some other configurations and will be updating
You can print 2 legs and 1 top, or if you want you can use 3 legs with 2 tops to make it larger
I used the Standard Profile on Cura with an Ender 3 V2
- Funko Leg takes 38min
- Funko Top takes 57min
A set of 2 legs and one top with my configurations uses about 16g (5.5m) of filament
The top part can be scaled to make it larger, but this size should be perfect for most pop figures.
I'm working on some other configurations and will be updating
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
