Thingiverse
Funky tower
von wesleyvz
15
Downloads
17
Likes
0
Makes
Around the inner tower there will be leds and then you just put the outer tower over it.
The inner tower is 5% infill and the outer i printed with 0% infill.
Height is about 250mm an width 100mm.
I have an other version of it with even narrower walls but that is a real retraction torture and i failed it 3 times, if there are people interested in trying it out just let me know and i will upload it to.
The inner tower is 5% infill and the outer i printed with 0% infill.
Height is about 250mm an width 100mm.
I have an other version of it with even narrower walls but that is a real retraction torture and i failed it 3 times, if there are people interested in trying it out just let me know and i will upload it to.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
