Thingiverse
Funnel Support for ring stand
di deschnell
135
Download
91
Likes
0
Makes
I needed a better support for my funnels - easier and faster to 3D print than to order from the catalog.
The first version was a bit small, version 2 has a 40mm support opening.
(Version 1 is the only one I have printed, and is shown in the photos).
Print support will be needed for version 2, but v1 can print without.
UPDATE: added Funnel Support_03 file with a cylinder "holder" instead of the polygon - again, untested - but should give a little better support. Slightly adjusted the position of the center pin for locking along thicker stand rods (or less flexible plastics).
The first version was a bit small, version 2 has a 40mm support opening.
(Version 1 is the only one I have printed, and is shown in the photos).
Print support will be needed for version 2, but v1 can print without.
UPDATE: added Funnel Support_03 file with a cylinder "holder" instead of the polygon - again, untested - but should give a little better support. Slightly adjusted the position of the center pin for locking along thicker stand rods (or less flexible plastics).
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
