Thingiverse
FuzNuz Jump Cup
di FuzNuz
36
Download
31
Likes
1
Makes
You will need a few other things for this project:
x2 --- 4x4 posts set into the ground or on stands of some nature
x1 --- 2" PVC pole of some length
x4 --- 3/8 inch standard hex nuts (Metric available on request)
x4 --- 3/8 inch by 1 inch long hex bolts (Metric available on request)
The bolts stick through the holes and then tighten into the nuts which rest in the plastic sockets, because the nut is fixed into the part you can gently tension it against the 4x4 post and have a fully adjustable height for the jump.
The jump cup holds the pvc pipe but allows for the pole to be knocked out of the way if the horse jumps too low and strikes it.
Again, I do not have a printer available to me at the moment, I have not tested this part at this point in time, use at your own risk.
x2 --- 4x4 posts set into the ground or on stands of some nature
x1 --- 2" PVC pole of some length
x4 --- 3/8 inch standard hex nuts (Metric available on request)
x4 --- 3/8 inch by 1 inch long hex bolts (Metric available on request)
The bolts stick through the holes and then tighten into the nuts which rest in the plastic sockets, because the nut is fixed into the part you can gently tension it against the 4x4 post and have a fully adjustable height for the jump.
The jump cup holds the pvc pipe but allows for the pole to be knocked out of the way if the horse jumps too low and strikes it.
Again, I do not have a printer available to me at the moment, I have not tested this part at this point in time, use at your own risk.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
