Thingiverse
Gaming controller stand
door LordEvilFish3DP
0
Downloads
1
Likes
0
Makes
A stand made to hold the DIY wired gaming controller. A simple print that you need to flip 90 degrees to the side to print without supports.
The stand holds up the tip of the controller around 2cm from the ground
Game controller itself:
https://www.thingiverse.com/thing:5404976
The stand holds up the tip of the controller around 2cm from the ground
Game controller itself:
https://www.thingiverse.com/thing:5404976
LordEvilFish3DP publiceert ook op
26 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
