Thingiverse
Gap Test
door Sp0ngeb0b
8
Downloads
2
Likes
0
Makes
Gap Tester - UPDATED
Prints in place , check your gap accuracy by printing this part.
Has a filet edge on the bottom to prevent seizing from "elephants foot". So you should not have to cut anything loose.
top and bottom gap is exacly the same also goes for center cavity only thing changing is the radius of the "barrel" inside... to look for play move side to side not up and down
spacing is 0.05mm increments but if you want to change them there is a freecad file all you need to do is change the barrel sketch to match the radius you want (change the numerical not the ss.barrel_pocket_radius) (you can change texts to match too! )
Prints in place , check your gap accuracy by printing this part.
Has a filet edge on the bottom to prevent seizing from "elephants foot". So you should not have to cut anything loose.
top and bottom gap is exacly the same also goes for center cavity only thing changing is the radius of the "barrel" inside... to look for play move side to side not up and down
spacing is 0.05mm increments but if you want to change them there is a freecad file all you need to do is change the barrel sketch to match the radius you want (change the numerical not the ss.barrel_pocket_radius) (you can change texts to match too! )
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
