Thingiverse
Gargoyle
von Tinkerman
28
Downloads
22
Likes
0
Makes
Gargoyle (working)
This is a working model of a gargoyle. The gutter on the back of the figure leads (rain)water trough it's throat.
It is scaled so that it fits the build area of the Peopoly Moai printer.
The use of supports is advised but the model will print 90% correct without supports (see example in gold)
Happy printing!
Tinkerman.
This is a working model of a gargoyle. The gutter on the back of the figure leads (rain)water trough it's throat.
It is scaled so that it fits the build area of the Peopoly Moai printer.
The use of supports is advised but the model will print 90% correct without supports (see example in gold)
Happy printing!
Tinkerman.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
