Thingiverse
Gear Puller
von PhoenixZip
3
Downloads
2
Likes
0
Makes
I'd reccomend 100% Infill.
This is untested, but will be shortly.
Designed to hold around a servo motor.
Used with a M3 bolt, with a Pin ground tip to apply pressure and drive the gear off.
This is untested, but will be shortly.
Designed to hold around a servo motor.
Used with a M3 bolt, with a Pin ground tip to apply pressure and drive the gear off.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
