Slicer Discord
Gecko trap – 3D-Druckmodell von Thingiverse Thingiverse

Gecko trap

1 Downloads
3 Likes
0 Makes
Zum Modell
If you're dealing with a gecko infestation at home, we have the perfect solution for you!

Our plan involves creating two possible entry points for the geckos, allowing them to enter either through the floor or the wall. To ensure maximum effectiveness, we have carefully designed a system with strategically placed openings that facilitate the dispersion of scent.

Take a square cardboard box
Cut two squares from it, one so that one side is adjacent to the floor but not the side attached to the floor.
The second hole should be adjacent to the wall on a side other than the side adjacent to the floor, at a height above half of the cut side.
Assemble the doors with hinges to the holes.
Drill as many holes as possible in the body of the cardboard.
Insert a bait with a strong scent such as mango, pineapple, or banana.
Take a disposable cup, fill it with water, and make a hole on the lower rolled part using a thin pin (water will come out in droplet form).
Finally, place the cardbo
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen