Thingiverse
Electronics
Go to Model
Generic Clip
56
Downloads
49
Likes
0
Makes
Yet another derivation of the Raspberry Pi clip by PatrickT, this one is for any board with 4 holes arranged in a rectangle.
I used it for a 2-relay board here, but you can edit the parameters to fit your own board.
OpenScad source provided so you can edit. Change the params below:
width_base: width between the centers of the gnubs
length_base: height between the centers of the gnubs
board_width: width of the board.
Other parameters are also present to add screws for holes, and change all other sizes.
I used it for a 2-relay board here, but you can edit the parameters to fit your own board.
OpenScad source provided so you can edit. Change the params below:
width_base: width between the centers of the gnubs
length_base: height between the centers of the gnubs
board_width: width of the board.
Other parameters are also present to add screws for holes, and change all other sizes.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
