Ghost Nightlight

Small USB nightlight, designed for 5mm or smaller LED

All the electronics are fitted into very little space, it may require a little patience with assembly.


### Components

>5mm white LED
>small switch (its optional)
>resistor (based on power source and LED)
>USB with 3mm cord diameter

Calculator for right resistor: https://www.digikey.com/en/resources/conversion-calculators/conversion-calculator-led-series-resistor

### Print settings:

>Opaque parts (holder & tombstone)
>>layer: 0.16mm
>>shell thicknes: 1.2mm
>>infill: 15%
>>material: grey PLA
>>raft: no

>Translucent parts (ghost)
>>layer: 0.1mm
>>shell thicknes: 0.8mm (with every layer less light will go through)
>>infill: 0% (there is no need for infill it would only block more light)
>>material: white PLA
>>raft: yes
>> support: 20%

There isn't any space for screws, you will need super glue or hot glue.
I personally tied knot with usb cord inside but in retrospective, I should have just glue