Slicer Discord
Ghost Post – 3D-Druckmodell von Thingiverse Thingiverse

Ghost Post

von JollyRgrs
0 Downloads
0 Likes
0 Makes
Zum Modell
There's a TikTok trend about using dollar store ghosts with dollar store paper towel holders but there's no good way to secure the ghost to the towel holder (glue/tape just wasn't going to cut it) so I made these. They are made specifically to fit the towel holders found at dollar tree in 2023 (YMMV if it is different sizes). The pieces fit tight but just slide into each other. It is easier to print as two pieces and allows some degree of flexibility if you desire your ghost to sit higher or lower on the stand.

Paper Towel Holder:
https://www.dollartree.com/product/219553
Ghosts:
https://www.dollartree.com/halloween-polyester-hanging-ghosts-36-in/275748
(Cauldron also from dollar tree)
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Kleben
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

JollyRgrs veröffentlicht auch auf

5 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen