Thingiverse
Household
Zum Modell
GHOSTS
1.1k
Downloads
864
Likes
15
Makes
GHOSTS are simple, decorative prints for Halloween and party decoration... or just for fun any time. Two files have been provided that mount in different ways.
The wall mount type is ready off the build plate to hang over a small nail or screw head (Head size up to 6.25mm / shaft size up to 3.0mm)
The hanging type needs to be threaded to hang. Thread down through the hole in the top into one of the eyes, thread across between the eyes, then thread back up and out the top. Translucent thread is the best to use as it's almost 'invisible' but harder to thread as you can't see its end easily. The 'easier threading tip' is to thread some coloured thread first, tie it onto the translucent thread and pull it back through in place of the coloured thread (Refer to images for additional understanding of this suggestion).
Easy and fun... GHOSTS look great printed in white and glow-in-the-dark filament.
At standard scale each ghost is 110mm tall. Scale up / down to suit but bear in
The wall mount type is ready off the build plate to hang over a small nail or screw head (Head size up to 6.25mm / shaft size up to 3.0mm)
The hanging type needs to be threaded to hang. Thread down through the hole in the top into one of the eyes, thread across between the eyes, then thread back up and out the top. Translucent thread is the best to use as it's almost 'invisible' but harder to thread as you can't see its end easily. The 'easier threading tip' is to thread some coloured thread first, tie it onto the translucent thread and pull it back through in place of the coloured thread (Refer to images for additional understanding of this suggestion).
Easy and fun... GHOSTS look great printed in white and glow-in-the-dark filament.
At standard scale each ghost is 110mm tall. Scale up / down to suit but bear in
muzz64 veröffentlicht auch auf
4 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
