Glass Bed Vise for FlashForge Creator Pro

NOTE: This solution is intended to be used with one or more manufactured products.

I'm not an accomplished glass cutter. When I cut a piece of glass to use as the surface for my FlashForge Creator Pro's heated print bed, it's usually not quite square. I found that I could put silvxm's glass bed clamp on three corners, but I needed a little better adjustability for gaps on the fourth. I made this combination of two bed clamp designs for that corner. For that last corner I can normally stabilize side or front using the contour from silvxm's solution, then close the distance to the other edge with an M3-0.5 X 20MM cap screw accommodated by 3Dpassion's solution.

I suggest using a material with a higher melting point than PLA, probably ABS or even nylon such as Taulman 645 or Taulman Bridge.

A fairly high resolution is required to ensure integrity of the threads for the cap screw.