Thingiverse
Glider box mount
von Rbzhlgg
18
Downloads
18
Likes
0
Makes
Put the nose into the fronth holder, then put down your tail into the clasp. Protect your precious glider with rubber foam glued to the inside of both parts.
To be printed in materials like PLA.
Front holder has an inner circle of 24mm and with foam glued in 20mm. Tail holder is designed for 13mm diameter fuses. (16mm width without foam)
To be printed in materials like PLA.
Front holder has an inner circle of 24mm and with foam glued in 20mm. Tail holder is designed for 13mm diameter fuses. (16mm width without foam)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
