Thingiverse
Globe Cube Stand
door OldManLink
195
Downloads
193
Likes
2
Makes
It's a stand for a standard 55 mm 3x3x3 twisty cube puzzle ("Rubik's Cube"). Pictured is the [QiYi WuWei M 3x3](https://speedcubeshop.com/products/qiyi-wuwei-m-3x3) , for which this stand was originally designed.
Note that the tolerance is pretty exact: a 56 mm cube will not fit. If your cube is any other size than 55 mm, you'll need to scale it by the factor n/55, where n is the length of a side of the cube. For best results, measure your cube using an accurate calliper that can measure to the nearest 0.1mm.
For example, for a 56 mm cube you will need to scale it up to 101.82%. For a 54 mm cube, scale it down to 98.18%. *Note:* scale the base by the same amount, or else you'll have problems fitting the two parts together.
Note that the tolerance is pretty exact: a 56 mm cube will not fit. If your cube is any other size than 55 mm, you'll need to scale it by the factor n/55, where n is the length of a side of the cube. For best results, measure your cube using an accurate calliper that can measure to the nearest 0.1mm.
For example, for a 56 mm cube you will need to scale it up to 101.82%. For a 54 mm cube, scale it down to 98.18%. *Note:* scale the base by the same amount, or else you'll have problems fitting the two parts together.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
