Glow Coaster

This coaster lights up when you place your glass on it.Parts and AssemblyThe piece consists of 3d Printed parts as well as a few things everybody should find in their house.The two Screws I found in a box of old dissassemblied electronics. The size is roughly 4 mm long and 1.5 mm in diameter.The filler is mainly here for pushing the LED assembly in place. I ended up not putting it in the final build because it was slightly to high.LED AssemblyThe LED is from a standard 5050 LED strip. I desoldered it from a piece I had laying around. Then I took a paperclip and straightened it with pliers, I then soldered the wire paperclip to the led and made bends according to the following sketch.Note: The 5050 LED actually houses 3 individual LEDs thats why there is 3 soldering points. To lower the brightness and energy consumption you could just solder 1 or 2 solderpoints to the wire.AssemblyStart by pushing the LED Assembly in the Main Body. Use the filler cube to make shure you push it in all th