Slicer Discord
goggle ventilator – 3D-Druckmodell von Thingiverse Thingiverse

goggle ventilator

35 Downloads
22 Likes
0 Makes
Zum Modell


THIS IS NOT TO BE USED IN ANY IDLH ENVIROMENT. SHOULD NOT BE USED FOR ANT INFECTIOUS DISEAS AREA OR INTRODUCTION TO. THERE IS NO FILTRATION I TAKE NO RESPONSABILITY FOR MISUSE

ok im not about to spend 80 dollars on a de fogging box for sealed eye protection. so here is my design. the electronics are set up for 9 volt battery 40mm fan exhaust direction down and a potentiometer. i take no responsibility or liability for any damage that is done if you wire wrong or dome your head off something and it catches fire or some weird thing. those looking for something like this know the missing part and how to use it. i used 35% infill and m4 alen screws. pushes air like a boss best luck and smaller unit is in the works. all the parts and pieces are proprietary to my design only.

items needed to complete are as follows
double sided gorilla tape.
40x40x10 12v brushless turbo blower fan
12v 2amp low voltage DC motor speed controller.
ultra bright 12 volt pre wired LED
1 9volt w
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen