Thingiverse
Goggles Case
por bmattas2
124
Descargas
85
Likes
0
Makes
Goggles case that snaps shut after super-glueing in magnets.
v1.0 is for 8x3mm magnets and v1.2 is for 12x5 mm magnets. Customizable to any size using the parameters at the top of the .scad files.
Hinges are printed in so no need for a separate hinge pin.
An idea for a remix would be to sink the magnet holes into the case 1 mm or so, then split the gcode up when printing and put the magnet in before the magnet hole is covered with it's first layer.
Haven't had much luck finding out if PLA is going to dissolve in cholrine water and would appreciate any feedback in the comments as to what filament materials would be good for chlorine water and saltwater.
v1.0 is for 8x3mm magnets and v1.2 is for 12x5 mm magnets. Customizable to any size using the parameters at the top of the .scad files.
Hinges are printed in so no need for a separate hinge pin.
An idea for a remix would be to sink the magnet holes into the case 1 mm or so, then split the gcode up when printing and put the magnet in before the magnet hole is covered with it's first layer.
Haven't had much luck finding out if PLA is going to dissolve in cholrine water and would appreciate any feedback in the comments as to what filament materials would be good for chlorine water and saltwater.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!