GPS Mount

This is printed using PETG as PLA will not stand up to the heat that this will see in the summertime. ABS maybe used as well. You will need a Harbor Freigh Spring Clamp that can be found at https://www.harborfreight.com/1-inch-capacity-steel-spring-clamp-39569.html and you will need (2) 3mm screws and nuts. Make sure that the screws do not protrude too far as they will mark the dash. Once assembled a drop of blue locktight or thread locker of your choice would be recommended.

Version 2 has been updated to a stronger base.