Thingiverse
GPU Brace/support
door smorgil
12
Downloads
6
Likes
0
Makes
This is a bracket meant to keep the GPU in your pc from "sagging"/"slacking" due to the weight of the GPU.
Your printer requires at least 135mm in both the Y and X-axis. Also, the model gets for some reason imported into slicers in the wrong orientation, so just remember to flip it so it's flat on the bottom side just like it is in the slicer screenshot.
You install it by unscrewing two of the screws in the GPU bracket and placing the 3D print over the metal sheet and screw the screws in again until it's pretty tight.
Just as a note I'm pretty sure this works with most 3 slots big GPUs, but I have an Asus dual RTX 2070 Super.
Your printer requires at least 135mm in both the Y and X-axis. Also, the model gets for some reason imported into slicers in the wrong orientation, so just remember to flip it so it's flat on the bottom side just like it is in the slicer screenshot.
You install it by unscrewing two of the screws in the GPU bracket and placing the 3D print over the metal sheet and screw the screws in again until it's pretty tight.
Just as a note I'm pretty sure this works with most 3 slots big GPUs, but I have an Asus dual RTX 2070 Super.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
