Thingiverse
GPU BRACER
door goodBEan
0
Downloads
0
Likes
0
Makes
A while back when I got a new GPU for my system I had a problem with the gpu bracket not fitting in my system. I initially picked up an aftermarket bracket but it seemed a bit underwhelming. Since it ended up being near the bottom of the case I decided to brace it against the floor.
Essentially you just need a few screws and lock nuts that fit and adjust. I recommend getting small rubber feet for the bottom. Only use this if your card is right near the bottom of the case and not bracing against another card.
I dont know what size screw and nuts I used.
The bracket
https://www.amazon.com/gp/product/B076GYL25H
Essentially you just need a few screws and lock nuts that fit and adjust. I recommend getting small rubber feet for the bottom. Only use this if your card is right near the bottom of the case and not bracing against another card.
I dont know what size screw and nuts I used.
The bracket
https://www.amazon.com/gp/product/B076GYL25H
goodBEan publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
