Thingiverse
GPU jack
door TectonicDiscoveries
20
Downloads
19
Likes
0
Makes
This print requires a 1' length piece of 5/16" diameter all thread and 2 corresponding nuts to each printed piece. The bottom has two M4 10mm holes which fit through a pre-cut 140mm fan mount in my case.
There are two different length jack pieces due the the size of the 1060 vs the 1070ti.
Use a nut at the top and bottom of each printed piece and turn to adjust height.
Edit: Added a new top brace to mount an 80mm fan to
There are two different length jack pieces due the the size of the 1060 vs the 1070ti.
Use a nut at the top and bottom of each printed piece and turn to adjust height.
Edit: Added a new top brace to mount an 80mm fan to
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
