Thingiverse
GPU Support Bracket (3 fan mini GPU)
von effbeecee
2
Downloads
2
Likes
0
Makes
Based on the ASRock Challenger RX 9070 (3 fan design). Probably can also be printed as a regular sized model too.
Fans are not able to spin but the file should be able to be printed in place. No supports needed.
The model is extremely small in mm so you should set it to somewhere around 500% size (~7 mm tall).
Fans are not able to spin but the file should be able to be printed in place. No supports needed.
The model is extremely small in mm so you should set it to somewhere around 500% size (~7 mm tall).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
