GPU Support Standoff

This is an extension standoff for the common GPU sag support that you can find online. For some PC cases where the bottom clearance is larger than the ~110mm that these supports can extend to, this addition will bridge the gap and give you sturdy support to the base of your case. Here is a link to the one I used: https://www.amazon.ca/Support-Bracket-Graphics-Holder-74mm-120mm/dp/B0C9ZYV1DK This standoff is sized to 14.50mm (nominal) in diameter, which is a good fit for the above support. The tolerance is pretty loose, this should work for any support between 10mm - 14mm without issue. The standoff will add an additional 60mm to the height of the support. If you need less than 60mm, please contact me and I'm happy to upload a profile with a smaller height. Model will print without supports. I recommend upping the wall count to 6 to ensure good structural strength as this part will be under load. IMPORTANT: Please print in PETG, ABS, ASA, or other heat tolerant material, the interio