Grass evolution 2 - HueForge

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm   You can complete this print without an AMS. Use the profile that says NO AMS and it will pause at the correct height instead of doing a filament change. At that point you change your filament and let it continue until the next pause where it will wait for the next manual filament swap.   Filaments Used: PLA Eryone Black Transmission Distance: 5 PLA Eryone Green Transmission Distance: 5 PLA Eryone Yellow Transmission Distance: 5 PLA Eryone White Transmission Distance: 5   Swap Instructions: Start with Black At layer #10 (0.88mm) swap to Green At layer #17 (1.44mm) swap to Yellow At layer #20 (1.68mm) swap to White for the rest.