Grass Man

So, the idea was to make a 3D printed ‘minion’-like silly green figure coated with grass particles (the stuff they use to make landscapes for miniature train sets).

3D-modeling
The 3D model was made in Blender using a few simple shapes, the eyes, teeth and tongue were later added and 'boolean-cut' from the body.

3D-printing
A nice thing about this technique that it masks ugly prints and rough layer thicknesses! :)

The f(l)ocking finish
For the green turf surface finishing I used multiple layers of 'scenic cement' from a company called Woodland Scenics (http://woodlandscenics.woodlandscenics.com/show/Item/S191/page/1) and covered it with the grass particles (I used these: http://woodlandscenics.woodlandscenics.com/show/Item/FT-W/page/1 but you can mix it up with different colors to get a specific look).

The process goes as follows, you spray the model, cover it with the particles, shake off any particles that are not stuck on the model and repeat the process until y