Thingiverse
Green Lantern Ring
door Orbnotacus
13
Downloads
7
Likes
0
Makes
I took a quick gander for a Green Lantern ring to print for my little one, but I wasn't happy with the results. So I just designed my own.
This one has ~13mm Inner Diameter, and all corners and edges have been rounded as to make it less hazardous for a child to wear while being a crazy child.
I resin printed mine, but if you were to FDM print it, I would suggest orienting the band parallel to the print bed, with the bottom face of the lantern symbol on the print bed, and printing supports up to the band, and underneath the ends of the top. I hope that makes ANY bit of sense.
NOTE: The rings in the picture, were BEFORE I rounded the edges of the symbol, but that's the only difference, and it's a small one, as I just didn't want it to have any sharp edges/corners.
This one has ~13mm Inner Diameter, and all corners and edges have been rounded as to make it less hazardous for a child to wear while being a crazy child.
I resin printed mine, but if you were to FDM print it, I would suggest orienting the band parallel to the print bed, with the bottom face of the lantern symbol on the print bed, and printing supports up to the band, and underneath the ends of the top. I hope that makes ANY bit of sense.
NOTE: The rings in the picture, were BEFORE I rounded the edges of the symbol, but that's the only difference, and it's a small one, as I just didn't want it to have any sharp edges/corners.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
