Gridfinity 1x2 Watch Case Version 2.1 (12U)

If you have a larger watch, there is now a wider 1x2 Gridfinity Watch Case (with approx 52.7mm of width inside), which you can find here: https://makerworld.com/en/models/1203806-gridfinity-1x2-wide-watch-case-version-3-0 This is a case designed to hold one watch using the Gridfinity system. I recommend using three of my remixed 1x2 Gridfinity Watch Holders with this case, linked below. https://makerworld.com/en/models/578185 With the TPU liner installed, this watch case is approximately 46.5mm in width, where the crown of a watch would typically sit (though it widens out by a couple mm if the holder is flipped so the watch faces rearwards. Without the TPU liner, the width is approx. 49.4-51mm. If the TPU liner is not used, the inside of the lid could be lined with felt to protect the watch. The TPU liner is designed to help limit vertical, and some sideways movement of the watch stand, so if it is removed to gain some width, the watch will have more room to bump around in the case (wh