Gridfinity 3x2 Watch Case (12U)

This is a case designed to hold three watches using the Gridfinity system. I recommend using three of my remixed 1x2 Gridfinity Watch Holders with this case, linked below. https://makerworld.com/en/models/578185 There is also a single watch case (pictured below), which is similar to this one. You can find it at the link below:https://makerworld.com/en/models/475248#profileId-385984 Although this is designed as a 12U case, it will not fit bins, due to the way the lid is designed. It is specifically designed as a watch case. Although there is only a gasket version, it will also work without a gasket. The gasket will not make it water tight, since there are too many factors that go into a water tight print and gasket. Please only make or use this case at your own risk. If you have any suggestions on how to make a more water resistant gasket, please let me know. The width of each watch slot is 45.9mm for the center, and 46.8mm for the outside slots, at the approximate location where the cr