Gridfinity Magnet Server

This 1x1 gridfinity module holds a stack of 20 6x2 magnets inside. Roll the thumbwheel and one magnet at a time is delivered to the top tray. You can operate the magnet server with one hand.

There are interior compartments, but if you fill them with magnets they will prevent the magnets from sliding forward to be served.

To assemble, print all three parts (bin, lid and disc). Insert a magnet from the outside into the single magnet detent on the outside. Then insert the disc so the pin fits into the slot. Finally insert a stack of 20 magnets. They should be attracted to the exterior magnet. Reverse them if they are repelled. Finally put the lid on.

To use simply rotate the thumbwheel. Remove each magnet as it is served. If more than a couple of magnets are in the tray they too can prevent the stack of magnets from moving forward to be served.

I added a photo showing how to piggyback more magnets inside without interfering with operation. When the column gets shor