Gridfinity Prototype Board Holder

Basic Explanation This is a simple holder that is made to store prototype boards that can drop onto a Gridfinity plate. It takes up two slots on the baseplate and is not stackable. There are no holes at the bottom for magnets. This holder can hold:8cm x 2cm boards (holds 3) (First slot)7cm x 3cm boards (holds 4) (Second Slot)6cm x 4cm boards (holds 3) (Third slot)7cm x 5cm boards (holds 3) (Fourth slot) ---------------------------------------------------------------------------------------------------------------- My print settings:I used the Bambu Lab A1 to print this and sliced using Bambu Studio. I used 15% infill. I used 2 Wall Loops. Kept this at the default setting.I did not enable supports. ---------------------------------------------------------------------------------------------------------------- Extra info about the holder:The holder is sloped (shown in image 3) so the shorter ones near the front can easily be picked up whilst the larger ones near the back have enough wall