MakerWorld
Organizers
Ver Modelo
Gridfinity USB A Holder x9 (2x1)
9
Descargas
1
Likes
0
Makes
Made this gridfinity holder for USB A devices like drives, recievers, and other small USB A devices. This one holds 9 drives. I was unable to orient them vertically as I would not have had enough clearance. The holes are the right size to balance snugness and ease for a standardized USB A port. Some stranger ports like the one seen on my little red drive in the picture have their own ports and may not fit. The size of the unit is 2x1 gridfinity squares, and rises 14mm above where it would fit in the grid (the taper to the main body). Hope it works out everyone else!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
