Thingiverse
Ground Nail
door ishumilin
1
Downloads
0
Likes
0
Makes
I had to get a replacement ground nail for my drone landing pad because some asshole drove over it while I was flying :(
This was the original item [https://de.aliexpress.com/item/1005006002356523.html] if you need it.
#### Print Settings
* Layer Height: 0.35 or lower
* Infill: 30%
* Material: PLA would do it but I would recommend something more rigid like carbon enforced filaments.
* Supports: not required
#### Postporcessing
Since dimensional accuracy does not matter so much, I would recommend to anneal it for extra strength.
This was the original item [https://de.aliexpress.com/item/1005006002356523.html] if you need it.
#### Print Settings
* Layer Height: 0.35 or lower
* Infill: 30%
* Material: PLA would do it but I would recommend something more rigid like carbon enforced filaments.
* Supports: not required
#### Postporcessing
Since dimensional accuracy does not matter so much, I would recommend to anneal it for extra strength.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
