Grump

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in size. You can change X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 4.5mm Filaments Used:PLA BambuLab Basic Black Transmission Distance: 0.6PLA BambuLab Basic Red Transmission Distance: 4PLA BambuLab Basic Orange Transmission Distance: 5PLA BambuLab Basic Blue Gray Transmission Distance: 3PLA BambuLab Basic Beige Transmission Distance: 8PLA BambuLab Basic Gray Transmission Distance: 0.5PLA BambuLab Basic Jade White Transmission Distance: 5This print uses 7 unique filaments. Substitute as needed. Swap Instructions:Start with BlackAt layer #13 (1.12mm) swap to RedAt layer #17 (1.44mm) swap to OrangeAt layer #18 (1.52mm) swap to Blue GrayAt layer #21 (1.76mm) swap to BeigeAt layer #27 (2.24mm) swap to GrayAt layer #29 (2.4mm) swap to BeigeAt layer #36 (2.96mm) swap to Jade White for the rest.Boost MeGot a Boost to s