Thingiverse
Guitar Footstool Basic
door Demishrike
69
Downloads
53
Likes
0
Makes
A basic footstool to lift my leg up when practising the guitar.
Dimensions: 135 x 250 x 90 mm (complete).
I split this because of the limited size of the printing bed. You need to print off two of the same *.stl file, each being 135 x 145 x 90 mm in size. For scale I've put my slipper on top in the image, I'm a UK 8.
I made it a tight fit so no gluing needed, but they do need a good bash together.
My printers maximum print speed is 35 mm/s and it takes about 8 h per side to print off. with 0.3 mm layer height. You probably need about 250 g of PLA including supports and brim to print both sides with the print settings below.
Dimensions: 135 x 250 x 90 mm (complete).
I split this because of the limited size of the printing bed. You need to print off two of the same *.stl file, each being 135 x 145 x 90 mm in size. For scale I've put my slipper on top in the image, I'm a UK 8.
I made it a tight fit so no gluing needed, but they do need a good bash together.
My printers maximum print speed is 35 mm/s and it takes about 8 h per side to print off. with 0.3 mm layer height. You probably need about 250 g of PLA including supports and brim to print both sides with the print settings below.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
