Hackbot Micro Pi Noon Bot

Here are the parts required to print the Micro Pi Noon Bot, chassis.
The post at the rear is designed to hold a metal coathanger formed to hold a balloon at the rear and a pin at the front of the bot, these are then used with the wiimote to joust, first person to pop the others balloon wins, usually a two person competition...

These were all printed on a Makerbot 2X

you will also need the following parts to complete the Pi Noon Bot
Pi Zero (various suppliers)
Bluetooth dongle (robot shop or similar)
4 x 50:1 metal gear motor/gearbox (pimoroni)
4 x wheels (pimoroni)
1 Astro Designs Pi-Z Moto motor control board
1 toggle switch (RS 317-645 or similar, hole size is 6mm)
Turnigy 1800mAh 2S 12C Lipo Battery Pack (hobbyking)
lipo battery checker (to see remaining charge on battery and check battery balance)
1 wiimote (ebay or amazon) !!! NOT THE WIIMOTE PLUS !!!
1 right angle micro usb to usb A, to plug the blue tooth dongle into the Pi (right angle fits better)
4 x 15 mm