Thingiverse
Half Bridge Load Sensor mount
por minko
42
Descargas
34
Likes
1
Makes
My version of a mount for a load cell. This is a single piece mount that holds the load cell using a little flange inside the housing, so that the load cell does not fall out.
Printing:
* Layer height: 0.25mm
* Extrusion width: 0.48mm
* Walls: 4
* Top/bottom layers: 3
* Infill: 40%
A small screw (with a cap diameter less than 6.2mm) is used to attach it.
To adjust the fit you can scale the model slightly.
Assembly: https://youtu.be/HNgFiMNhTBk
Printing:
* Layer height: 0.25mm
* Extrusion width: 0.48mm
* Walls: 4
* Top/bottom layers: 3
* Infill: 40%
A small screw (with a cap diameter less than 6.2mm) is used to attach it.
To adjust the fit you can scale the model slightly.
Assembly: https://youtu.be/HNgFiMNhTBk
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
