Thingiverse
Hammer
von LLIA
5
Downloads
14
Likes
0
Makes
HAMMER *updated FEB 11, 2024
Made for the Ender 3v2 with the SPIDER V3 hotend, CR touch, and Sprite SE extruder kit.
For use with 2, dual ball bearing blower fans 4020.
Holes will need to be drilled and tapped or drilled and heat pressed with threaded inserts, 3mm. Some holed are clearance holes for mounting to already threaded parts. Some might need to be drilled larger for clearance. Use Heat tape to protect wires near the hot end.
Made for the Ender 3v2 with the SPIDER V3 hotend, CR touch, and Sprite SE extruder kit.
For use with 2, dual ball bearing blower fans 4020.
Holes will need to be drilled and tapped or drilled and heat pressed with threaded inserts, 3mm. Some holed are clearance holes for mounting to already threaded parts. Some might need to be drilled larger for clearance. Use Heat tape to protect wires near the hot end.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
