Thingiverse
Handcuffs (without additional hardware)
door Seemomster
190
Downloads
138
Likes
2
Makes
This is an remix of a wonderful pair of handcuffs, desingned by sthone.
For the finished handcuffs you'll need 10 'Handcuff_Pin.STL' to hold everything together.
Also 2 Pins of 1.75 Filament are needed to secure the locking-bar (red on 3nd the pic).
For the second cuff mirror,
-'Handcuff_Casing.STL'
-'Handcuff_Casing_Face.STL'
(-'Handcuff_Locking_Arm_Bow.STL', only to have the same surface, but technically not needed)
in your slicer.
The key is a normal handcuff key
(for example: https://www.thingiverse.com/thing:752482)
For the finished handcuffs you'll need 10 'Handcuff_Pin.STL' to hold everything together.
Also 2 Pins of 1.75 Filament are needed to secure the locking-bar (red on 3nd the pic).
For the second cuff mirror,
-'Handcuff_Casing.STL'
-'Handcuff_Casing_Face.STL'
(-'Handcuff_Locking_Arm_Bow.STL', only to have the same surface, but technically not needed)
in your slicer.
The key is a normal handcuff key
(for example: https://www.thingiverse.com/thing:752482)
Seemomster publiceert ook op
89 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
