Thingiverse
Handle
door AT3chnicality
9
Downloads
8
Likes
0
Makes
A handle i made to replace the cheap one that snapped on a cabinet.
hole spacing 77mm (center to center give 'r take)
screw hole size 3.6mm
overall length 98mm
width 9.8mm
i printed it with pla at .1 sliced in cura
also printed with 3 walls so the screws would have something to bite into.
hole spacing 77mm (center to center give 'r take)
screw hole size 3.6mm
overall length 98mm
width 9.8mm
i printed it with pla at .1 sliced in cura
also printed with 3 walls so the screws would have something to bite into.
AT3chnicality publiceert ook op
30 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
