Handy Driver V1 Magnetic

Little Wera inspired screwdriver for hex bits. Requires a D6x3mm magnet. Simple instructions, no glue or supports needed:Start print.After 14mins print will pause.Remove the printed dowel from the bed.Insert a D6x3mm magnet into the hole on the part printed screwdriver.Insert the printed dowel in the same hole.Push both down until flush (should be a nice snug fit).Resume the print and they are captivated.Print time is about 30 mins, and takes less than a min to insert the magnet and dowel half way through. Works a charm. Might make another in the future with a snap fit spinning top. Uploaded now, see V2 in my profile.