Handy Driver V2 Magnetic

Little Wera inspired screwdriver for hex bits. Requires a D6x3mm magnet. This version includes a snap fit top that is free to spin. Simple instructions, no glue or supports needed:Start print.Step 1 - After 20mins the print will pause.Step 2 - Insert a D6x3mm magnet into the hole on the part printed screwdriver.Step 3 - Remove the printed dowel from the bed and insert in the same hole.Step 4 - Push both down until flush (should be a nice snug fit).Resume the print and they are captivated.Finally remove the cap and body from bed and snap them together.Print time is about 35 mins (change the layer height to improve the finish on the Cap recess if desired), and takes less than a min to insert the magnet and dowel half way through. Works a charm. Print Profile 2 - Also, the parts can be split into different build plates for a different coloured Cap and Body. If you do this, I firstly print the Lid and Dowel in one colour on one plate and the Body on a second plate (with a pause to insert m